Sony Playstation VR Aim Controller Display Stand Assembly Manual
Love for games
Overview
Your parts may differ from the picture. This is because almost all stands are individually adapted to consoles. However, the principle is the same for all 3-part stands.
Two holders are inserted into a base plate.
DS Lite and GBA SP consoles are placed on the stand with the module slot.
Small Parts
It should be clear and obvious, but:
Contains small parts! Keep away from children!
SUPER IMPORTANT!!!!!!111
Remove Foil
Remove the protective film from both sides of all parts before assembly!
Otherwise the parts will be damaged!
The film can be blue, green or milky colored, sometimes transparent clear.
If you have trouble removing it, gently scratch along one edge with a plastic card.
Also super important!!!!
Attention
If the pieces don't fit, flip the base over. *Carefully* twist and tilt the pieces until they drop into the socket.
Then press the parts into the openings.
The protective film MUST be removed before installation.
Super easy
Assembly
Lay the base plate flat on the table. First, insert the main bar into the base plate, as shown in the illustration. Carefully.
With feeling
Final Steps
Then you insert the remaining parts into the base plate and the main bridge, as shown in the illustration. Again: Carefully.
Finally, carefully place the Sony Playstation VR Aim Controller on top. Be careful, it can easily tip over.
Sustainable!
Disposal Instructions
The packaging material is recyclable, the cardboard and filling material are made from recycled paper. Simply reuse the cardboard, filling material and bag! Use them to store things or send games that you want to get rid of.