Wired Controller Display Stand Assembly Manual
Love for games
Overview
Your parts may differ from the picture. That's because almost all stands are custom made. However, the principle is the same for all four-part controller stands. Two holders are inserted into a base plate, and a strut makes everything stable.
Small parts
It should be clear and obvious, but:
Contains small parts! Keep away from children!
SUPER IMPORTANT!!!!!!111eleven
Remove foil
Remove the protective film from both sides of all parts before assembly!
Otherwise the parts will be damaged!
The film can be blue, green or milky colored, sometimes transparent clear.
If you have trouble removing it, gently scratch along one edge with a plastic card.
Also super important!!!!
ATTENTION
If pieces don't fit, flip the base over. *Carefully* wiggle and tilt pieces until they drop into the socket.
Then press the parts into the openings.
The protective film MUST be removed before assembly.
DO NOT wrap the cable TOO TIGHT!!! The stand is intended for display and NOT for daily use of the controller!
Super easy
Assembly
Lay the base plate flat on the table. Put the parts together as shown in the picture. The strut is inserted last. Carefully.
Sustainable!
Disposal instructions
The packaging material is recyclable, the cardboard and filling material are made from recycled paper. Simply reuse the cardboard, filling material and bag! Use them to store things or send games that you want to get rid of.